Setup Location Requirements; Electrical Connection; Design And Function - CASO DESIGN Classico T 2 Original Bedienungsanleitung

12.5 Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
• The device must be placed on a flat, stable and heat-resistant surface.
• Do not use the device outdoors.
• Do not operate the device near hot surfaces (e.g.hot plate), an open gas flame or in a
hot oven.
• The device and the power cord must not come into contact with hot surfaces. The
device could be damaged.
• Do not place the device on a metal surface.
• Choose the setup location in such a way that children cannot reach the hot surfaces of
the device.
• The device is not intended to be installed in a wall or a built-in cupboard.
• Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.
• The device requires sufficient airflow to function properly. Leave a 10 cm free space
around the device.
• Do not cover any openings on the device or block them.
• The socket outlet must be easily accessible so that the connecting cable can be easily
disconnected in an emergency.

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following
instructions must be observed for the electrical connection:
• Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that
no damages occur in the device. If in doubt, ask your qualified electrician.
• The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fire that is involved with this.
• Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
• The electrical outlet must be protected by a 16A safety cut-out switch.
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing
or damaged protective conductor.

13 Design and Function

In this chapter, you'll find important information on the design and function of the device.
31