Setup Location Requirements; Electrical Connection - CASO DESIGN Classico T2 Duo Original Bedienungsanleitung

DE

3.4 Setup location requirements

EN
In order to ensure the safe and trouble-free operation of the device, the setup location
FR
must fulfi l the following prerequisites:
•
The device must be placed on a fl at, stable and heat-resistant surface.
IT
•
Do not use the device outdoors.
•
Do not operate the device near hot surfaces (e.g.hot plate), an open gas fl ame or in a
NL
hot oven.
•
The device and the power cord must not come into contact with hot surfaces. The
RUS
device could be damaged.
•
PL
Choose the setup location in such a way that children cannot reach the hot surfaces
of the device.
•
PT
The device is not intended to be installed in a wall or a built-in cupboard.
•
Do not set up the device in a hot, wet or extremely damp environment or near fl am-
mable material.
•
The device requires suffi cient airfl ow to function properly. Leave a 10 cm free space
around the device.
•
Do not cover any openings on the device or block them.
•
The socket outlet must be easily accessible so that the connecting cable can be easily
disconnected in an emergency.

3.5 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instruc-
tions must be observed for the electrical connection:
•
Before connecting the device, compare the connection data (voltage and frequen-
cy) on the rating plate with those of your electrical network. This data must agree in
order that no damages occur in the device. If in doubt, ask your qualifi ed electrician.
•
The connection between the device and the electrical network may employ a 3 meter
long (max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs
or gangs is prohibited because of the danger of fi re that is involved with this.
•
Make sure that the power cable is undamaged and has not been installed under the
ice maker or over hot or sharp surfaces.
•
The electrical outlet must be protected by a 16A safety cut-out switch.
•
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. If in doubt, have the house installati-
on checked over by a qualifi ed electrician. The manufacturer cannot be made respon-
sible for damages that are caused by a missing or damaged protective conductor.
24 CASO Classico T2 Duo