Hints And Tips - AEG FEE62600PM Benutzerinformation

16 www.aeg.com
• The indicator of the running phase
is on.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay repeatedly until the
display shows the desired delay time
(from 1 to 24 hours).
3. Press Start to begin the countdown.
• The indicator
• The remaining time counts down
in hours. The final hour is
displayed in minutes.
When the countdown is completed, the
programme starts and the indicator of the
running phase is on. The indicator
off.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry function.
Cancelling the delay start
while the countdown
operates
When you cancel the delay start, you
have to set a programme and options
again.

10. HINTS AND TIPS

10.1 General
Follow the hints below to ensure optimal
cleaning and drying results in daily use
and to protect the environment.
is on.
is
Press and hold simultaneously Delay
and Option until the appliance is in
programme selection mode.
Cancelling a programme
Press and hold simultaneously Delay
and Option until the appliance is in
programme selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is complete, the
display shows 0:00. The indicator
on.
All buttons are inactive except for the
on/off button.
1. Press the on/off button or wait for the
Auto Off function to automatically
deactivate the appliance.
If you open the door before the
activation of Auto Off, the appliance
is automatically deactivated.
2. Close the water tap.
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the programme is
complete.
• After 5 minutes if a programme was
not started.
• Washing dishes in the dishwasher as
instructed in the user manual usually
consumes less water and energy than
washing dishes by hand.
• Load the dishwasher to its full
capacity to save water and energy.
is