Maintenance And Cleaning; Repair & Maintenance - Concept VT 7030 Bedienungsanleitung

OPERATING INSTRUCTIONS
1. Place the unit on a stable surface or floor to prevent it from tipping over. Remove the entire feed cord
from the storage space and uncoil it.
2. Connect the power cord plug to the wall outlet.
3. Select the required function using the mode selector:
0
= Off
= Cool air
1
= heating capacity (850 W )
2 = Full heating capacity (approximately 1500 W ).
4. You may set the required temperature in the room using the thermostat regulator. When heating
function (1) or (2) is selected, the unit will alternately switch on and off, thus keeping the required
temperature.
Note: A more accurate temperature can be set as follows:
Set the thermostat to the maximum, and switch the heating to (1) or (2) . When the required
temperature has been reached in the room, turn the thermostat slowly to a lower temperature, until the
unit switches off.
If you use the fan in the cool air mode
5. After use, move the mode selector to the (0) position and unplug the unit from the mains.
Safety switch against overturning the device
Safety switch against overturning stops operation, when the device is overturned or is placed inappropriate manner
that undermines security.
Reset instructions
1. Unplug the heater and wait 20 minutes for the unit to cool down.
2. After the 20 minutes, plug the unit in again and operate normally.

MAINTENANCE AND CLEANING

WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects, as
they may damage the unit's surface!
The air inlet and outlet grilles should be cleaned frequently to ensure proper operation of the unit and to
avoid overheating.
Dust accumulated in the unit may be blown out or removed by a vacuum cleaner.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!
REPAIR & MAINTENANCE
Any extensive maintenance or repair that requires access to the inner parts of the product must be
performed by an expert service centre.
VT 7030
, set the thermostat regulator to the maximum.
EN
25