Maintenance And Cleaning; Troubleshooting - Concept VT 7010 Handbuch

EN
EN
Caution
will vanish after a short time.
Note: Do not use the unit in rooms smaller than 4 m
OPERATING INSTRUCTIONS
1. Place the unit on a stable surface or fl oor to prevent it from tipping over. Remove the entire feed cord from the
storage space and uncoil it.
storage space and uncoil it.
2. Connect the power cord plug to the wall outlet.
2. Connect the power cord plug to the wall outlet.
3. Select the required function using the mode selector:
0 = Off
= Cool air
= Cool air
1 = 50% heating capacity (750 W )
2 = Full heating capacity (approximately 1500 W ).
4. You may set the required temperature in the room using the thermostat regulator. When heating function (1) or
(2) is selected, the unit will alternately switch on and off , thus keeping the required temperature.
Note: A more accurate temperature can be set as follows:
Note:
Set the thermostat to the maximum, and switch the heating to (1) or (2) . When the required temperature
has been reached in the room, turn the thermostat slowly to a lower temperature, until the unit switches off .
If you use the fan in the cool air mode
been reached in the room, turn the thermostat slowly to a lower temperature, until the unit switches off.
5. After use, move the mode selector to the (0) position and unplug the unit from the mains.

MAINTENANCE AND CLEANING

Warning!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents or hard objects, as they may
overheating.
Dust accumulated in the unit may be blown out or removed by a vacuum cleaner.
Never clean the unit under running water, do not rinse it, and do not submerge it in water!

TROUBLESHOOTING

location of the unit to improve the air circulation in and around the unit.
VT6930 VT 7010
2
.
, set the thermostat regulator to the maximum.
19 19