Bestway Fast Set Bedienungsanleitung Seite 5

7. The selected location must not have overhead power lines or
trees. Be sure the location does not contain underground
utility pipes, lines or cables of any kind.
8. The selected position must be far from house entrance. Do not
position any equipment or other furniture around the pool. The
water that comes out of the pool during the use or due to a
faulty product can damage the furniture inside the house or
surrounding the pool.
9. The selected surface must be flat and without holes that can
damage the material of the liner.
Follow the important instructions above to choose the correct
surface and location to set up your pool. Damaged parts of the
pool, due to the fact that the set-up surface and location does not
match the instructions, will not be considered as manufacture
defect and will avoid the warranty and any service claims.
Suggested set-up surfaces: grass, ground, concrete, and all
other surfaces that respect the above set-up conditions.
Not suggested surfaces: mud, sand, gravel, deck, balcony,
driveway, platform, soft/loose soil or other surface that does not
meet the above set-up conditions.
NOTE: Check with your local city council for by-laws relating to
fencing, barriers, lighting and safety requirements and ensure
you comply with all laws.
NOTE: If have a filter pump, refer to the pump's manual for
instructions.
NOTE: The ladder must match the pool size and should be used
only for entering and exiting the pool. It is forbidden to exceed
the permitted payload of the ladder. Check regularly if the ladder
is properly assembled.
INSTALLATION
Installation usually takes approximately 10 minutes with 2-3
people excluding earthworks and filling.
Bestway will not be responsible for damage caused to the pool
due to mishandling or failure to follow these instructions.
ATTENTION: Do not use a high pressure air hose or over-inflate
the top ring, it should be slightly stiff to the touch.
NOTE: Do not use extension power cords to power your pump.
ATTENTION: Do not drag the pool on the ground, this can
damage the pool.
NOTE: The base or bottom of the pool should be laid out
properly (flat without wrinkles).
NOTE: Hot temperatures cause air to expand the ring and may
cause damage. Leave some room for expansion. For assistance
or FAQs, please visit the support section on our website,
www.bestwaycorp.com.
NOTE: Drawings for illustration purposes only. May not reflect
actual product. Not to scale.
POOL MAINTENANCE
If you do not adhere to the maintenance guidelines below, your health might be at risk, especially that of your children.
Using chemical tablets (not included):
NOTE: Chemconnect or Chemical Floater must be used when you perform chemical maintenance with tablets. Your purchased item
may not include any of those dispensers, in this case you can purchase it by visiting our website www.bestwaycorp.com or at the
nearest pool dealer.
1
3
5
FILLING POOL WITH WATER
ATTENTION: Do not leave pool unattended while filling with water.
1. Fill the water until the wall is straight up, and the water
reaches the welding line. DO NOT OVERFILL as this could
cause the pool to collapse. In times of heavy rainfall you may
need to empty some of the water to ensure the level is correct.
2. When filling the pool is completed, check that the water is not
collecting on any side to ensure the pool is level.
IMPORTANT: If pool is not level, drain water and re-level ground
by digging out. Never attempt to move the pool with water in it,
serious personal injury or damage to the pool may result.
WARNING: Your pool may contain a great deal of pressure. If
your pool has any bulge or uneven side, then the pool is not
level, the sides may burst and the water may discharge suddenly
causing serious personal injury and/or damage to property.
5
2
4
0°