Herunterladen Inhalt Inhalt Diese Seite drucken

Bestway Fast Set Bedienungsanleitung Seite 5

Vorschau ausblenden Andere Handbücher für Fast Set:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

INSTALLATION
Installation usually takes approximately 10 minutes with 2-3
people excluding earthworks and filling.
Bestway will not be responsible for damage caused to the pool
due to mishandling or failure to follow these instructions.
ATTENTION: Do not use a high pressure air hose or over-inflate
the top ring, it should be slightly stiff to the touch.
NOTE: Do not use extension power cords to power your pump.
ATTENTION: Do not drag the pool on the ground, this can
damage the pool.
NOTE: The base or bottom of the pool should be laid out
properly (flat without wrinkles).
NOTE: Hot temperatures cause air to expand the ring and may
cause damage. Leave some room for expansion. For assistance
or FAQs, please visit the support section on our website,
www.bestwaycorp.com.
NOTE: Connect a garden hose to the adapter located on the
inflatable top ring to activate the water sprayer (Coconut palm).
NOTE: When the water sprayer (Coconut palm) is engaged,
please open the valve located on the upper outside wall to drain
excess water. This will prevent overflow and allow the pool to
maintain it's structure. When the water sprayer is not active,
close the valve to prevent water from draining.
NOTE: Drawings for illustration purposes only. May not reflect
actual product. Not to scale.
POOL MAINTENANCE
If you do not adhere to the maintenance guidelines below, your health might be at risk, especially that of your children.
Using chemical tablets (not included):
NOTE: Chemconnect or Chemical Floater must be used when you perform chemical maintenance with tablets. Your purchased item
may not include any of those dispensers, in this case you can purchase it by visiting our website www.bestwaycorp.com or at the
nearest pool dealer.
IMPORTANT: Don't use granulate tablets or throw the tablet directly in the water. The chemicals can deposit on the bottom, damage
the material and discolor the PVC.
Using chemical liquid (not included):
IMPORTANT: Add chemical liquid in small doses and in the center of the pool to avoid direct contact between the chemicals and the
PVC surface. Direct contact can damage the material and discolor the surface.
NOTE: Remove the chemical dispenser from pool when the pool is in use.
IMPORTANT: After performing chemical maintenance and before using the pool, use a test kit (not included) to test the water
chemistry. We recommend maintaining your water according to the following table.
Coconut palm has the built-in
water sprayer.
FILLING POOL WITH WATER
ATTENTION: Do not leave pool unattended while filling with
water.
1. Fill the water until the wall is straight up, and the water
reaches the welding line. DO NOT OVERFILL as this could
cause the pool to collapse. In times of heavy rainfall you may
need to empty some of the water to ensure the level is correct.
2. When filling the pool is completed, check that the water is not
collecting on any side to ensure the pool is level.
IMPORTANT: If pool is not level, drain water and re-level ground
by digging out. Never attempt to move the pool with water in it,
serious personal injury or damage to the pool may result.
WARNING: Your pool may contain a great deal of pressure. If
your pool has any bulge or uneven side, then the pool is not
level, the sides may burst and the water may discharge suddenly
causing serious personal injury and/or damage to property.
5

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

57416

Inhaltsverzeichnis