Circuit diagrams
10
Circuit diagrams for KstW 200 / KstWT 200
Kompakt Wärmeblock
10.1
Connection without filter control
Electrical installation must comply with local regulations and
VDE 0100. For safety reasons, the residual current circuit brea-
ker ∆N = 30 mA must be used for the principal mains connec-
tion. All metal parts must be included in the equipotential bon-
ding.
Terminals 11 and 12 must have a 230V~ supply, otherwise the controller cannot
function (correct terminal-phase association not required)
Caution:
For information on attaching the
advance sensor, see page 19, point 1.7
(sensor included)
16