Potential Hazards - Behncke KstW 200 Installationsanleitung

Safety
Operating range for heat exchanger:
Type A for fresh water
Chloridkonzentration
Chlorine concentration
Type B for sea water
Chloride concentration
Chloride concentration
Operating point
Heating
Pool water
Thermal output/flow temperature
(at pool water inlet temperature of 20°C)
Type 47,5
Conversion and modification of the heat exchanger is prohibited
for safety reasons
1.4

Potential hazards

The heat exchanger may be damaged.
The heat exchanger may start to leak if the maximum operating overpressure of
2.5 bar on the pool water side or 6 bar on the heating water side is exceeded.
take care
There is a risk of fire.
Connections on the heating water side of the heat exchanger may reach tempe-
ratures of as high as 100°C.
The heat exchanger may heat up to the flow temperature of the heating water if
caution
pool water is not flowing through it.
4
< 400 mg/l
permanent:
transient
< 5000 mg/l
permanent:
transient
Volumetric flow rate
2000 l/h
10000 l/h
47,5 KW / 90°C
0,8 mg/l
1,2 mg/l
0,8 mg/l
1,2 mg/l
40,7 KW / 80°C 33,9 KW / 70°C