5.
Kabel einführen.
1.
Leitungstülle 10 in die ausgewählte
Kabeleinführung 16 oder 17 eindrücken.
Darauf achten, daß die Dichtlippen an der
Leitungseinführung korrekt anliegen.
Hinweis:
Bei einem Leiterquerschnitt von 16 mm
Leitungstülle nicht verwenden. Das Gerät
muß dann wandbündig montiert werden.
Achtung: Ohne Leitungstülle besteht nur
ein Spritzwasserschutz (IP24).
8
2.
Das Gerät auf das Anschlußkabel
setzen.
3.
Das Gerät auf die Gewindebuchse 7
setzen und mit Mutter 8 verschrauben.
16
5.
Insert the cable.
1.
Press cable grommet 10 into the
selected cable aperture 16 or 17 . Ensure
that the sealing lips are correctly positioned
on the cable aperture.
Note:
2
die
If the cable cross-section is 16 mm
NOT use the cable grommet. The appliance
must then be installed on the wall.
Note: If the cable grommet is not used,
the appliance is protected only against
splashwater (IP24).
7
10
2.
Place the appliance on the connecting
cable.
3.
Place the appliance on the threaded
bush 7 and screw on nut 8 .
5.
1.
2
, do
IP24
8 7
10
16
2.
3.
8
10
16
17
16
7