Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
ASSEMBLY
Step 1
1
Attach wheel assembly to base. Line
up holes in wheel bracket with cor-
responding holes in base, insert two
bolts M8 x 16 through holes, and
finger tighten two M8 flange nuts.
Be sure that the wheel assembly is
parallel to the base, and fully tight-
en bolts.
AA
BB
2
3
Step 2
2-1. Put the 3 pcs post brackets on
each position on the base as shown
in the picture.
4
2-2. Use 3 Medium Bolts(M8x16) to
join the post brackets and stand.
BB
Step 3
3-1. Put the post on the top of 3 pcs
post brackets.
3-2. Use 6 Large Bolts and Flange
Nuts (M6) to connect the post to
the 3 pcs post brackets. Tighten the
bolts and nuts.
CC
EE
Step 4
Place the tank housing on the stand.
13
Werbung
Inhaltsverzeichnis
