Iberital L’ANNA Installations- Und Betriebshandbuch Seite 49

This alarm signal is either due to an obstruction to the fl ow of water, and the control unit receives slower and more
drawn out impulses than during the normal feed time, or because the coff ee is ground very fi nely or packed in the
fi lter too tightly, causing excess weight, thus preventing the water from fl owing with suitable fl uidity.
D. DEPOSIT LEVEL INDICATORS (only Iberital L'Anna Handy)
This machine has a system for indicating both minimum and maximum levels, which works as follows:
Minimum Level – When the water tank reaches its minimum level, the control unit cuts the current to the
button pad and the heating element, in order to prevent damage to both the element and the pump due to a
lack of water. At that moment the LEDs on the button pad will begin to fl ash, advising the user that the deposit
must be fi lled.
When we begin to fi ll the deposit manually and the water covers the minimum level sensor, the LEDs will turn off
and the control unit will once more allow the electrical current to reach the element and pump.
Maximum Level – When we are fi lling the tank manually with water and reach the maximum level, the LED on
the non-stop button lights up, indicating that we must stop adding water to the deposit. This LED will remain lit
until the water level is below the maximum level sensor.
GENERAL WARNING: If your machine has a visual display, the respective alarm will be shown on the screen
based on the incident (see the section on visual display operation).
2.3.4. Programming hot water (only available on New Iberital and Iberital Expression
Enter programming mode, pressing the 'non-stop' button for 5 seconds on the group 1 button pad (left); the 'non-
stop' LED will light up.
NOTE (versions with visual display and miscellaneous solenoid valve): At the same time there is a manual
regulator found on the side of the water mixing solenoid valve.
2.4.- HOT WATER DISPENSER
Place the cup or any other recipient under the hot water dispenser (8). Turn the hot water knob (18) in order to
begin dispensing water and turn it back again to stop it, or press the hot water dosage button if your machine
features one.
2.5.- STEAM DISPENSER
INSTALLATION AND OPERATION MANUAL
Downloaded from www.Manualslib.com
Two models)
- If the option 'NO' MIXED TEA is selected on the visual display or for machines without visual
display:
• Press the hot water button. At that moment hot water will begin to come from the boiler.
• When the desired dose has been obtained, press the hot water button again.
• The hot water setting has been programmed.
- If the option MIXED TEA is selected on the visual display or for machines without visual
display:
• Press the hot water button. At that moment mixed water (hot/cold) will begin to come from
the boiler.
• Press the hot water button. At that moment hot water will begin to come from the boiler.
• When the desired dose has been obtained (fi rst press + second press), press the hot water
button again.
• The fi nal hot water setting has been programmed.
a) Twist the steam dispenser (9) towards the tray (15).
b) Open the steam tap (7), and in order to remove condensation let the steam fl ow out until no water
droplets accompany it.
c) Position the steam dispenser (9) inside the liquid recipient you wish to heat. Turn the knob (7)
to release the steam. In order to obtain a frothy cappuccino, keep the mouth of the steam ejector
close to the surface of the milk. This will create an abundance of foam/froth.
d) When the liquid has reached the desired temperature, close the steam tap.
e) Move the recipient containing the liquid, removing the steam dispenser (9) and aiming it at the
tray (15).
f) Open the steam tap (7) for a moment, in order to remove residue stuck to the steam dispenser (9).
Clean the steam dispenser (9) with a damp cloth or sponge.
manuals search engine
IBERITAL
Page 49