Technical Data; Rating Plate - AEG HK955070XB Benutzerinformation

16 www.aeg.com
Problem
The sensor fields become
hot.
There is no sound when you
touch the panel sensor
fields.
comes on.
and a number come on.
You can hear a constant
beep noise.
comes on.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass

9. TECHNICAL DATA

9.1 Rating plate

Model HK955070XB
Typ 60 HCD AA AO
Ser.Nr. .................
Possible cause
The cookware is too large or
you put it too near to the
controls.
The sounds are deactivated. Activate the sounds. Refer to
Child Safety Device or Lock
operates.
There is an error in the hob.
The electrical connection is
incorrect.
The second phase of the
power supply is missing.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
PNC 949 595 020 04
220 - 240 V 50 - 60 Hz
Made in Germany
7.9 kW
Remedy
Put large cookware on the
rear zones if possible.
"Daily use".
Refer to "Daily use".
Deactivate the hob and acti‐
vate it again after 30 sec‐
onds. If comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin‐
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a
qualified electrician to check
the installation.
Check if the hob is correctly
connected to the electrical
supply. Remove the fuse,
wait one minute, and insert
the fuse again.