Dali mentor Anleitung Seite 7

UK DE DK
3.1 MENTOR 5, 6, 8
the speakers are designed to stand on the floor. using spikes or rubber bumpers under the
speakers, (see Figure 3 +4). Be careful not to over tighten the contra nuts. Spikes or rubber
bumpers can improve the sound quality. You can try both to hear what gives the best sound quality
in your setup. Please be aware, that spikes may damage the floor, if it is not protected.
Note:
On some floor surfaces and in some rooms, the use of spikes is a crucial aspect of obtaining
the best result. the spikes included on MENtOR 8, 6 and 5, should be screwed in loosely in the
threaded holes in the bottom of the speaker. Place the loudspeaker upright on its spikes on the
floor, so that it stands steadily without rocking. tighten the nuts, so that the four spikes sit tightly.
these assembly and setup steps ensure stable mechanical coupling to the surface beneath.
3.2 MENTOR 2
DALI recommends that you place your MENtOR 2 on a stand for the optimum sound experience.
Alternatively, MENtOR 2 can be placed on a shelf. the enclosed rubber bumpers can be mounted
under the speaker for stable and vibration-free positioning (see figure 4).
3.3 MENTOR MENUET + MENTOR 1
the speakers can be positioned on a stand/shelf or hung on the wall using an optional wall
bracket(s). If positioned on a stand or shelf, the enclosed rubber bumpers can be placed under the
speaker for stable and vibration-free positioning (see figure 4). For wall mounting you must use an
optional wall bracket(s) (available at all DALI dealers). Before mounting the speakers to the wall,
position the special bumpers, which are enclosed in the wall bracket packaging, on the rear edge
of the speaker. these bumpers ensure the correct distance from the wall.
3.4 MENTOR VOKAL
MENtOR VOKAL is the ultimate center channel and should be placed on a stand or a shelf.
the enclosed rubber bumpers can be placed under the speaker for stable and vibration-free
positioning (see figure 5).
3.5 MENTOR LCR
MENtOR LcR is suited for placement on a wall or lying on a shelf (as a center channel). For wall
mounting, use the two integrated wall brackets on the rear side of the speaker. Fix two screws in
the wall, a distance of 430 mm/16.9" apart, on which the speaker can hang. Position the screws
above each other if the speaker is used as Left or Right speaker (vertically – see figure 6) or next
to each other if the speaker is used as a center channel speaker (horizontally – see figure 7).
If placed on a shelf/stand and used as a center channel, the enclosed rubber bumpers can be
placed under the speaker for stable and vibration-free positioning (see figure 5).
9