Herunterladen Inhalt Inhalt Diese Seite drucken

Dali mentor Anleitung Seite 12

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Remote Control (see figure 12)
A)
Standby ON/OFF
Press to toggle between the two states (ON/OFF switch on the rear panel must be set to
ON).
Note:
When the AutO/MANuAL switch is set to AutO, the subwoofer cannot be turned off with
signal on the inputs.
B)
Mute
Press to mute the subwoofer. the display on the front of the subwoofer will show "---".
Press again to un-mute the subwoofer.
C,D,E) Phase, frequency and volume adjustment
Press the relevant button and adjust to the desired value using the '+' and '-' buttons. the
display on the front of the subwoofer will show the selected value:
FREQuENcY RANGE: 40 - 120 Hz
VOLuME RANGE: 0 - 30 dB
PHASE RANGE: 0°, 90°, 180° or 270°
F)
Memories 1, 2 & 3
When you have adjusted Frequency, Volume, Phase to the desired values, they can be
stored in and recalled from the memory positions 1, 2 and 3.
to store a preset: Press and hold the desired memory button (1, 2 or 3) on the remote for
more than 3 seconds. When the values are stored as a preset, the subwoofer display will
confirm by flashing "-1-", "-2-" or "-3-" three times, according to the memory you have
selected.
Please note that existing presets in the memory will be over written, if settings are restored
in one of the memories.
to recall a preset: Briefly press the desired memory button (1, 2 or 3). When a preset is
recalled, the subwoofer display will show "-1-", "-2-" or "-3-" for 2 seconds according to
the memory you have recalled.
G)
Battery
Open the battery compartment on the remote and insert the battery as on the illustration
(see figure 14). When the battery needs to be replaced (depends on frequency of use), use
ONLY a lithium cell battery type cR2025,3V.
ATTENTION! Keep the remote out of reach of children as they might be choked by
eating the remote or parts of it including the battery.
Display (see figure 13)
On the front of the subwoofer there is a translucent logo badge/display. the settings of the
subwoofer can be seen on the display when the subwoofer is operated by the remote control or
the buttons on the amplifier.
14

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis