Dali mentor Anleitung Seite 11

3) Power LED
LED off: Mains power is Off
LED green: Subwoofer is On
LED red: Subwoofer is in Stand-by mode
4) Auto/manual
Flick the switch to the desired position.
AutO: Switch up = the subwoofer will automatically power up upon detection of an input
signal on the LINE IN inputs. the Subwoofer will power down after approximately 20
minutes with no input signal present on the input connectors.
MANuAL: Switch down = Stand-by only possible via the Remote control.
5) Left + right line inputs
using these inputs activates the built-in crossover and makes crossover Frequency and
Phase adjustment possible.
use these inputs for the stereo set-up
LEFt: connect to the LEFt RcA line output on your stereo/surround (pre-) amplifier.
RIGHt: connect to the RIGHt RcA line output on your stereo/surround (pre-) amplifier.
6) LFE line input
using this input by-passes the built-in crossover. All adjustments must be done from your
surround (pre-) amplifier.
use this input for surround systems e.g. 5.1 and 7.1.
LFE: connect to the LFE RcA line output on your surround (pre-)amplifier.
7) ON/OFF switch
Switch to turn the subwoofer On/Off from the mains supply.
8) Mains fuse - ATTENTION!
If the subwoofer does not power up in the ON position, the fuse might be blown. to replace
the fuse, unplug the mains cable, open the fuse compartment and replace the fuse with
one of the same type .If the fuse blows multiple times, have the subwoofer serviced by
qualified personnel. Please note that the voltage range written below the mains fuse holder
must match the voltage of your mains supply.
120V version: use/replace w.t5AL/250V fuse
220-240V version: use/replace w.t2.5AL/250V fuse
UK DE DK
13