Starting The Machine - Zipper Maschinen ZI-BES350Y Betriebsanleitung

o If you see that the saw blade is getting slower – you push the machine too fast
 Cuts with cutting depth of more than 90mm should be performed in two consecutive
working steps.

Starting the Machine

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
1. Turn the fuel valve to the "O
2. Set the engine /
ON
the "On" position.
Note: The closed position of the choke lever enriches
the fuel mixture for starting a cold engine. The open
position provides the correct fuel mixture for normal
operation after starting and for restarting a warm
engine.
3. Turn the choke lever to the "Closed" position, only
for cold engine.
4. Set the throttle lever to "half throttle" (= middle
position between "fast" and "slow").
Note: Do not pull the starter rope through to the end
and do not let it rewind after pulling, but only rewind it
quickly.
5. Grab the starter handle and pull it out slowly. The
resistance becomes strongest at a certain point. This
point corresponds to the compression point. Let the
rope roll back a little from this point and then pull it
out powerfully.
6. Turn the choke lever to "Open when the engine is
running.
7. Open the shut-off valve on the bottom of the water
tank.
8. Crank the cutting blade slowly down, until it has
reached the desired cutting depth in the material.
" position.
N
switch (ignition switch) also to
OFF
OPERATION
23
ZI-BES350Y