Recycling; Troubleshooting - Zipper Maschinen ZI-BES350Y Betriebsanleitung

19 STORAGE
If the machine is not used for a longer period of time (>30 days):
1. Empty the oil tanks or fuel tank.
2. Remove the spark plug and pour a few drops of engine oil into the cylinder. Using a
rope starter, turn the engine a few times so that the oil is well distributed inside the
cylinder. Clean the spark plug and replace it.
3. Cover the cooled machine and store it out of the reach of children and unauthorised
persons in a well-ventilated, dry and frost-free environment.
20

RECYCLING

Do not dispose of your machine in residual waste. Contact your local authorities for
information on available disposal options. If you buy a new vibratory plate or
equivalent from your dealer, he is obliged in certain countries to dispose of your old
machine properly.
21

TROUBLESHOOTING

Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out
troubleshooting work and secure it against unintentional restarting.
Failure
If the engine does not want to
start:
When the engine stops:
When engine output drops:
Diamond cutting disc vibrates
Diamond cutting disc does not
cut
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
W A R N I N G
Possible root-cause / measure
Check the ON/OFF switch if it is „ON"

Check the fuel cock if on

Check for fuel, check the fuel pipe for leaks

Cold start / warm start difference

Spark plug

Carburator or air filter polluted.

Check fuel supply chain.

Check motor oil level.

Check air filter.

Check the air filter.

 Nut/flange not tightened/ set cor-rectly  tighten
 Nut flange is dirty  clean and tighten
Cutting disc not mounted correctly  check

 Cutter disc is dull  renew
 Wrong cutter disc  choose suitable one
STORAGE
26
ZI-BES350Y