Hitachi H 90SC Bedienungsanleitung Seite 7

IMPORTANT
Correct connection of the plug
The wires of the mains lead are coloured in accordance
with the following code:
Blue — Neutral
Brown — Live
As the colours of the wires in the mains lead of this
power tool may not correspond with the coloured
markings identifying the terminals in your plug proceed
as follows:
The wire coloured blue must be connected to the terminal
marked with the letter N or coloured black. The wire
coloured brown must be connected to the terminal
marked with the letter L or coloured red. Neither core
must be connected to the earth terminal.
NOTE
This requirement is provided according to BRITISH
STANDARD 2769: 1984.
Therefore, the letter code and colour code may not be
applicable to other markets except United Kingdom.
Information concerning vibration
The measured values were determined according to
EN60745.
The typical weighted root mean square acceleration
value: 21.0 m/s 2
Information about power supply system of nominal
voltage 230 V~
Under unfavorable mains conditions, this power tool
may cause transient voltage drops or interfering voltage
fluctuations.
This power tool is intended for the connection to a
power supply system with a maximum permissible
system impedance Z
MAX
point (power service box) of the user's supply.
The user has to ensure that this power tool is connected
only to a power supply system which fulfills the
requirement above.
If necessary, the user can ask the public power supply
company for the system impedence at the interface point.
of 0.36 Ohm at the interface
English
6