ASROCK H61M-GS Bedienungsanleitung Seite 21

All manuals and user guides at all-guides.com
2.7 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATA2_0: see p.2, No. 9)
(SATA2_1: see p.2, No. 10)
(SATA2_2: see p.2, No. 11)
(SATA2_3: see p.2, No. 12)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 15)
USB_PWR
(9-pin USB8_9)
(see p.2 No. 16)
1
USB_PWR
Infrared Module Header
(5-pin IR1)
(see p.2 No. 22)
Print Port Header
AFD#
ERROR#
(25-pin LPT1) PINIT#
SLIN#
(see p.2 No. 20)
1
SPD4
SPD3
SPD2
SPD1
SPD0
STB#
ASRock H61M-GS / H61M-S Motherboard
These four Serial ATAII
SATA2_0
(SATAII) connectors support
SATA2_1
SATA data cables for internal
storage devices. The current
SATA2_2
SATAII interface allows up to
SATA2_3
3.0 Gb/s data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII hard disk or the
SATAII connector on this
motherboard.
Besides six default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
P-9
P+9
GND
DUMMY
GND
P+8
P-8
This header supports an
IRTX
+5VSB
optional wireless transmitting
DUMMY
and receiving infrared module.
1
GND
IRRX
This is an interface for print
port cable that allows
GND
convenient connection of printer
devices.
SPD7
SPD6
ACK#
SPD5 BUSY
PE
SLCT
21