Herunterladen Inhalt Inhalt Diese Seite drucken

Schumacher SCI10 Bedienungsanleitung Seite 6

Vorschau ausblenden Andere Handbücher für SCI10:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 17
9.
OPERATING INSTRUCTIONS
WARNING
assembly instructions before it is used.
Battery Information
This charger can be used with 6 and 12V batteries with rated capacities of
12 Ah to 111 Ah.
Charging
1. Ensure that all of the charger components are in place and in good working
condition, for example, the plastic boots on the battery clips.
2. Connect the battery, following the precautions listed in sections 5 and 6.
3. Connect the AC power following the precautions listed in section 7.
4. Select the appropriate settings for your battery.
IMPORTANT
by plugging in the charger to the AC wall outlet. The charger will not supply current to
the battery clips until a battery is properly connected. The clips will not spark if touched
together.
Battery Connection Indicator
If the charger does not detect a properly connected battery, the CONNECTED
will not light. Charging will not begin if the CONNECTED
Automatic Charging Mode
When a charge rate is selected, the charger is set to perform an automatic charge.
When an automatic charge is performed, the charger switches to the maintain mode
automatically after the battery is charged.
Aborted Charge
If charging cannot be completed normally, charging will abort. When charging aborts,
the charger's output is shut off and the CHARGING
charger ignores all buttons. To reset after an aborted charge, unplug the charger from
the AC outlet, wait a few moments and plug it back in.
Desulfation Mode
IMPORTANT
the car's electrical system may result.
If the battery is left discharged for an extended period of time, it could become sulfated
and not accept normal charge. If you select
mode of operation designed for sulfated batteries. If successful, the charger will fully
desulfate and charge the battery, then the green LED will go on. If desulfation fails, the
charger will abort and the CHARGING
Completion Of Charge
Charge completion is indicated by the CHARGED
stopped charging and switched to the Maintain Mode of operation.
Maintain Mode
When the CHARGED
mode, the charger keeps the battery fully charged by delivering a small current when
necessary. The voltage is maintained at a level determined by the battery type selected.
Maintaining a Battery (2A
This charger has a maintenance setting that maintains both 6 and 12 volt batteries,
keeping them at full charge. On this setting, it can charge small batteries and maintain
both small and large batteries. We do not recommend charging a large battery on the
maintenance setting.
NOTE: The maintain mode technology utilized in Schumacher's chargers allows you
to safely charge and maintain a healthy battery for extended periods of time. However,
problems with the battery, electrical problems in the vehicle, improper connections
or other unanticipated conditions could cause excessive current draws. As such,
occasionally monitoring your battery and the charging process is recommended.
This battery charger must be properly assembled in accordance with the
This charger does not have an ON/OFF switch. ON and OFF are controlled
Battery must be removed from the car when using this mode, or damage to
LED is lit, the charger has started Maintain Mode. In this
, the charger will switch to a special
(yellow) LED will blink.
Charge Rate)
6
LED is not on.
LED. When lit, the charger has
LED

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis