Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TIP: The operating time with a fully charged rechargeable battery is approximately 18 minutes (in Power mode) or
40 minutes (in Eco mode).
Vacuuming with the floor nozzle
TIP: The floor nozzle can also be used without the suction tube in order to vacuum furniture, for instance. When
doing so, make sure that the surface can withstand the contact with the brush roller without sustaining damage.
Vacuuming in Power mode
In Power mode the hand-held vacuum cleaner operates with higher power and the brush roller rotates.
1.
Attach the floor nozzle to the suction tube.
2.
Push the switch forward two steps to switch on the appliance. Power mode is activated; the LEDs light up.
3.
Vacuum the floor.
4.
Push the switch back as far as it will go to switch off the appliance.
5.
Empty and clean the dust container (see chapter "Maintaining the appliance").
Vacuuming in Eco mode
Vacuuming is carried out with reduced power in Eco mode. The hand-held vacuum cleaner consumes less energy and the
operating time of the rechargeable battery is extended. The brush roller also rotates in this context.
1.
Attach the floor nozzle to the suction tube.
2.
Push the switch forward by one position to switch the device on.
Eco mode is activated; the LEDs light up.
3.
Vacuum the floor.
4.
Push the switch back as far as it will go to switch off the appliance.
5.
Empty and clean the dust container (see chapter "Maintaining the appliance").
Use the crevice tool or the 2-in-1 tool
TIP: The 2-in-1 tool can also be used without the suction tube, e.g. for use on furniture. With the 2-in-1 tool, the
brush attachment can be retracted by moving the red slider, for example to pick up crumbs. The crevice tool is also
suitable for use in corners where access is difficult.
1.
Attach the crevice tool or the 2-in-1 tool to the device directly, or to the suction tube.
2.
Push the switch forward one step (Eco mode) or two steps (Power mode) to switch on the appliance.
3.
Vacuum the floor.
4.
Push the switch back as far as it will go to switch off the appliance.
5.
Empty and clean the dust container (see chapter "Maintaining the appliance").
Emptying the dust container
The dust container can only hold a limited quantity of dirt.
It is therefore best to empty the dust container after every cleaning procedure and if the suction power noticeably drops.
1.
Make sure that the appliance is switched off and is not on charge.
2.
Take the suction tube off (see
3.
Open the flap on the underside of the dust container. To do so, push the slider forward.
4.
Empty the dust container.
5.
Close the flap.
Operating the appliance
Maintaining the appliance
Figure II).
15
Werbung
Inhaltsverzeichnis
