Livin Flame Noville Montageanleitung Und Gebrauchsanweisung Seite 17

SECTION 3: OPERATING INSTRUCTIONS
This appliance can be operated by both remote control and manual buttons. Once the unit has been
properly connected to an earthed electrical outlet, turn on the main switch located on the top right-
hand side of the front of the appliance. A beep should be heard when the power is first applied.
NOTE! To use both remote and manual functions the manual on/off switch must be in 'ON'
position.
In order to protect the product not becoming too hot, there is 10 seconds delay when turning on
the heater; also, there is 10 seconds delay when turning off the heater fan.
3.1 Operating by Manual Button
NOTE! The manual button on the fire box unit will not provide you with all function control, and its
purpose is to control some basic function when you lose the remote handset. Please use the remote
handset to carry out all functions.
MANUAL SWITCH
Press the switch to switch the appliance ON or OFF.
POWER ON/OFF BUTTON
Press "POWER ON/OFF" to enter standby mode.
FLAME BUTTON
Press "FLAME" button to select the colour of flame (3 colours) or return to the OFF position. Press for
3 seconds to cancel the beep sound every time you press the button, two short beeps indicate it is
cancelled.
HEATER BUTTON
Press "HEAT BUTTON" to cycle through LOW heater, HIGH heater and OFF.
WIFI BUTTON
Press to enter Wi-Fi mode.
NOTE: The controls on appliance will lose the memory for all function settings when the switch is
set to the Off Position. When the remote runs out of power or when you change the batteries, only
the flame function will lose memory and will not affect the timer settings, however, the clock may
need adjusting.
17