Makita GD0602 Bedienungsanleitung Seite 3

ENGLISH (Original instructions)
1-1. Slide switch
2-1. Wrench 13
SPECIFICATIONS
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for grinding ferrous materials or
deburring castings.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical
according to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Vibration
The vibration
determined according to EN60745:
Work mode : surface grinding
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
Downloaded from www.Manualslib.com
2-2. Collet nut
2-3. Wrench 13
Model
Max. collet capacity
Max. wheel point diameter
Rated speed (n)/No load speed (n
Overall length
Net weight
Safety class
A-weighted noise level
) : 75 dB(A)
pA
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s or less
h,SG
2
manuals search engine
Explanation of general view
)
0
ENE050-1
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
•
ENF002-2
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG905-1
the times when the tool is switched off and when it
determined is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
ENG900-1
Die Grinder
vector sum)
Model No./ Type: GD0602
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following
standards or standardised documents:
ENG902-1
EN60745
The technical documentation is kept by:
Makita International Europe Ltd.
Technical Department,
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
3
5-1. Side handle
GD0602
8 mm
38 mm
-1
25,000 min
264 mm
1.4 kg
/II
Corporation as the responsible
ENH101-16