Remote Control - Samsung HW-J8500R Bedienungsanleitung

DESCRIPTIONS

remoTe ConTroL

● operate the TV using the TV's remote control.
SOURCe
Press to select a source connected to the Soundbar.
Mute
you can turn the volume down to 0 with the push of a button.
Press again to restore the sound to the previous volume level.
Repeat
The repeat function is available only when playing back music from Songs on phone
or DmS of Samsung multiroom app.
Off - RePeat : Cancells repeat Playback.
tRaCK - RePeat : Plays a track repeatedly.
aLL - RePeat : Plays all tracks repeatedly.
Skip forward
If there is more than one file on the device you are playing, and you press
the ] button, the next file is selected.
SOUnD COntROL
Press to select tReBLe, BaSS or aUDiO SynC. Then, use the [,]
buttons to adjust the tReBLe or BaSS volume from -3 ~ +3.
Press and hold the SOUnD COntROL button for about 5 seconds to adjust
the sound for each frequency band. 150Hz, 300Hz, 600Hz, 1.2KHz, 2.5KHz,
5KHz, and 10KHz are selectable and each can be adjusted to a setting between
-6 ~ +6.
If the Soundbar is connected to a digital TV and the video appears out of sync
with the audio, press the SOUnD COntROL button to sync the audio with the
video. Use the [,] buttons to set the audio delay between
0 ms ~ 300 ms. In TV mode, and BT mode, the audio Sync function may not
available.
anynet+
Press the anynet+ button to turn the anynet+ function on or off.
(Default : auto Power Link off, On - anynet+ / Off - POWeR LinK or Off
- anynet+ / On - POWeR LinK). The anynet+ function lets you control the
Soundbar with the remote from an anynet+ compatible Samsung TV.
The Soundbar must be connected to the TV via an HDmI cable.
* auto Power Link
Synchronizes the Soundbar to a connected optical source via the optical
jack so it turns on automatically when you turn on your TV. (See page 21)
auto Power Link function is only available in the D.in mode.
you can also activate Wi-fi SetUP function by pressing and holding anynet+
button on the remote for over 7 seconds.
8