Control Panel - HQ Power VDPL170MH17 Bedienungsanleitung

 The device has a power output [8] to supply power to another device. When connecting several devices in
a daisy chain via this output, make sure that the total current does not exceed the power line's nominal
current. Use power cables with an adequate section.
 The installation has to be approved by an expert before the device is taken into service.
DMX-512 Connection
 When applicable, connect an XLR cable to the female XLR output of a controller (not incl.) and the other
side to the male XLR input [11,12] of the device. Multiple devices can be linked through serial linking. The
linking cable shall be a dual core, screened cable with XLR input and output connectors.
 Maximum recommended serial data link distance is 500 meters (1640 ft). Maximum recommended number
of devices on a serial data link is 32 devices.
 A DMX terminator is recommended for installations where the DMX cable has to run a long distance or is in
an electrically noisy environment (e.g. discos). The terminator prevents corruption of the digital control
signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω resistor between pins
2 and 3, which is then plugged into the XLR output socket [9,10] of the last device in the chain.
7. Operation
The device can be used in the following modes:
 stand-alone mode: automatic or sound-activated
 master/slave
 with a DMX512 controller.
7.1

Control Panel

Control Buttons
Access the control panel functions using the four panel buttons [4] located on the right-hand side of the
display [3].
Button Function
MENU to access the menu, quit the current function without saving the setting, or quit the menu
UP to scroll upward in a list of functions or options, or increase a value
DOWN to scroll downward in a list of functions or options, or decrease a value
ENTER to confirm and save a selected option or value
LED Indicators
On the left-hand side of the display are the following LED indicators [2]:
 DMX: lights up in DMX mode
 Master: lights up in master mode
 Slave: lights up in slave mode
 Sound: lights up in sound-activated mode.
7.2 Display Settings
Switching off the Display Automatically
1. Press MENU to open the menu.
2. Select <Display Setup>, then select <Back Light>.
3. Select the desired setting:
<On>: to keep the display always on.
o
<Off>: to switch the display off after 15 seconds of inactivity.
o
Setting the Display Brightness
1. Press MENU to open the menu.
2. Select <Display Setup>, then select <Back Light Dimmer>.
3. Set the display brightness from low to high (1–100).
Rotating the Display Readout
If you mount the device upside down, you can rotate the display readout by 180°:
1. Press MENU to open the menu.
2. Select <Display Setup>, then select <Display Inverse>.
V. 01 – 10/02/2014
VDPL170MH17
5 ©Velleman nv