Conformity Declaration - Sagola 4600 Scrambler Gebrauchsanleitung

ANOMALIES
Incorrect spraying
The fluid needle does
not close
20.

Conformity Declaration

In accordance with UNE-EN ISO/IEC 17050-1 (ISO/IEC 17050-1:2004)
Manufacturer:
Address:
Hereby declares that the product: AEROGRAPHIC SPRAY GUN
Brand:
Range:
BATCH:
In accordance with the Esential Security Provisions on the Annex of the Directive 94/9/CE.
The product conforms with the standards:
• Directive of machines (2006/42/CE) and the corresponding transposition into national law 1644/2008.
• EN 1953:2013
- Atomising and spraying equipment for coating materials. Security requirements.
• UNE-EN 12100:2012
- Safety of machinery. General principles for design. Risk assessment and risk reduction.
These also meets the following Regulations and Directives:
Non electrical equipment:
ATEX Directive (Directive 94/9/CE)
Protection Level II 2G Suitable for use in Zones 1 and 2
"X"marking All static electricity is discharged through air pipes (the air hoses must be "STATIC-FREE")
UNE EN-13463-1:2011
- Non electrical equipment used for potentially explosive atmospheres.
Full technical documentation and service instructions are available.
In Vitoria-Gasteiz on 01/10/2017
CAUSES
Dirty air nozzle
Inadequate air pressure
Inadequate amount of product
Inadequate viscosity
Spray width opening
Foreign bodies in fluid tip
Dirty packing gland in head
Inadequate Tip+ needle combination
Product regulator
excessively open
Needle spring worn
or not fitted to gun
Product with foreign bodies
SAGOLA, S.A.
Urartea, 6 01010 VITORIA-GASTEIZ (Alava) SPAIN
SAGOLA
4600 Scrambler
(See the back page of this Manual)
o
II 2G T60 C X
ENGLISH
REMEDY
Clean the nozzle
Adjust the pressure
Adjust the amount
Adjust the viscosity
Adjust
Eliminate particles and
clean
Clean and/or lubricate
Replace
Adjust adequately
Replace or fit
Filter
Signed
Technical Manager
Enrique Sánchez Uriondo