Inhaltsverzeichnis
Werbung
operations with the back of the handset kept 5mm
from the body. The device complies with RF
specifications when the device used at 5mm from
your body. The use of belt clips, holsters and similar
accessories should not contain metallic components
in its assembly. The use of accessories that do not
satisfy these requirements may not comply with RF
exposure requirements, and should be avoided.
8. FCC/IC information
This device complies with Part 15 of the FCC Rules and
with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference recei-
ved, including interference that may cause undesired
operation.
Changes or modifications made to this equipment
not expressly approved by RugGear Ltd. may void
the FCC authorization to operate this equipment.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux
conditions suivantes:
① l'appareil ne doit pas produire de brouillage, et
② l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation. If this equipment does
EN
9
Werbung
Inhaltsverzeichnis
