Inserting / Replacing Batteries; Connecting Camera; Basic Functions - VOLTCRAFT BS-200XW Bedienungsanleitung

7.

InSERTIng / REpLACIng BATTERIES

1. Loosen the screw using a Phillips screwdriver and take off the cover of the battery compartment.
2. Remove the battery holder from the battery compartment.
3. Insert four AA batteries into the battery holder, observing the polarity markings inside the battery
holder bays.
4. Put the battery holder back into the battery compartment, observing the polarity markings on the
top of the battery holder and inside the battery compartment.
5. Close the battery compartment again.
Replace the batteries when the battery LED is on.
8.

ConnECTIng CAmERA

1. Connect the plug of the gooseneck camera to the socket on the base unit. The protruding metal
tongue on the camera's plug should be facing the recess on the front side of the socket.
2. Slide the screw cap upwards, toward the camera and screw the screw cap counter-clockwise to
fasten the camera.
3. Follow these steps in reverse order when disconnecting the camera from the base unit.
9.

BASIC funCTIonS

only immerse the camera head and camera neck in liquids that are voltage free!
The camera neck is not to be submerged further than the marking "mAX Water
Level".
The endoscope may only be used for inspection of dead systems. The camera head
is made of metal and can lead to short circuits. for safety reasons, disconnect all
system parts from the power supply before every inspection.
Avoid strong mechanical strains or vibrations. make sure you never go below the
minimum bending radius of 45 mm.
1. Press the on/off button to switch the device on. The power LED will turn on and the camera image
will appear in the monitor.
2. Two LEDs are integrated in the camera head.
- Press the button ↑ to increase the brightness of the LEDs.
- Press the button ↓ to reduce the brightness of the LEDs or to turn the lighting off entirely.
Set the lighting so that the camera image displayed is neither overexposed nor
underexposed.
3. Press the buttons ↑ and ↓ simultaneously to rotate the image by 180º.
18