Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance And Adjusting; Cleaning, Checks And Storage - Christopeit Sport CS 2000 Montage- Und Bedienungsanleitung

Walking laufband zum geh- und lauftraining
Vorschau ausblenden Andere Handbücher für CS 2000:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

MAINTENANCE AND ADJUSTING

1. Lubrication for the running belt:
In order to keep the machine in the best condition, please add some
Silicone oil between the running belt and the running board after 50
hours or 1 to 2 month of use. But the running belt may slip, if you lu-
bricate too much. To lubricate the belt please pull the walking belt up
and injection the silicone oil into the gap between belt and walking
deck.
2. Adjusting running belt:
You need to adjust the walking belt to the normal position, per the fol-
lowing steps if it is off.
a. Set speed at 3-5km.
b. Using the Allen key to adjust the belt tension bolt on the end cap of
the system frame.
c. If you want to move the belt towards left, turn the right tension bolt
clockwise.
d. If you want to move the belt towards right, turn the left tension bolt
clockwise.
e. If you have already done according to the steps above and it is still
not at the good range, then the running belt should be damaged alrea-
dy, please contact your local dealer for replacement.
Note: Make sure that the running surface is as centered as possible.
Once these moves too far from the center, (about 10 mm) it should be
readjusted into the center.
3. Running belt slips:
a. Make sure the walking belt is not too loose.
b. Make sure the motor belt is not too loose.
4. No light on the Display:
a. Check if the power plug is properly connected.
b. Check if the safety key at handgrip right is in place.
5. Overload protection:
The fuse compartment (B) is located between the main switch (A) and
the mains connection socket (C) for the main connection. There is a mi-
crofuse 5x20mm with the data 5A / 250V.
6. Abnormal noise from the machine:
a. Check if any screw of machine is loose.
b. Check if the motor belt is off.
c. Check if the running belt is off.
Note: Please contact your local dealer if you have checked all the ab-
ove listed things but the problem is still there.

CLEANING, CHECKS AND STORAGE

1. Cleaning
Use only a less wet cloth for cleaning. Caution: Never use benzene, thinner or other aggressive cleaning agents for surface cleaning as this dama-
ge caused. The device is only for private home use and for use suitable indoors. Keep the unit clean and moisture from the device.
2. Storage
Plug out the power supply unit while intending the unit for more than 4 weeks not to use. Choose a dry storage in-house. Cover the product to
protect it from being discolor by any sunlight and dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for tightness, which were prepared in the assembly.
12
GB
59

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

2030

Inhaltsverzeichnis