Electrolux IK3035CZR Benutzerinformation Seite 15

All manuals and user guides at all-guides.com
Problem
The compressor does not
start immediately after
pressing the "FastCool", or
after changing the temper‐
ature.
Water flows inside the re‐
frigerator.
Temperature cannot be
set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The "FastCool function"
is switched on.
This is normal, no error
has occurred.
Food products prevent
the water to flow into the
water collector.
The "FastCool function"
is switched on.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
ENGLISH
Solution
Wait few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastCool function".
The compressor starts after
a period of time.
Make sure that food prod‐
ucts do not touch the rear
plate.
Switch off "FastCool func‐
tion" manually, or wait until
the function resets automati‐
cally to set the temperature.
Refer to "FastCool function".
Keep the OK pressed for ap‐
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Add less food products at
the same time.
Open the door only if neces‐
sary.
15