Specifications - Makita MT582 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Depth guide
1-2. Lever
2-1. Clamping screw
3-1. Base plate
4-1. Lock button / Lock-off button
4-2. Switch trigger
5-1. Hex wrench
5-2. Shaft lock
6-1. Saw blade
6-2. Outer flange

SPECIFICATIONS

when using 190 mm diameter
Max. cutting
depth
when using 185 mm diameter
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Explanation of general view
6-3. Hex bolt
6-4. Inner flange
7-1. Mounting shaft
7-2. Inner flange
7-3. Saw blade
7-4. Outer flange
7-5. Hex bolt
8-1. Mounting shaft
8-2. Inner flange
8-3. Saw blade
Model
Blade diameter
blade
blade
-1
)
Overall length
Net weight
Safety class
) : 95 dB(A)
pA
) : 106 dB(A)
WA
at 90°
at 45°
at 90°
at 45°
ENE028-1
Work mode : cutting chipboard
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
ENF002-1
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
ENG905-1
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG900-1
3
8-4. Outer flange
8-5. Hex bolt
9-1. Hex wrench
11-1. Screw
11-2. Rip fence
12-1. Limit mark
13-1. Brush holder cap
13-2. Screwdriver
MT582
185 mm - 190 mm
68 mm
46 mm
66 mm
44 mm
4,900
297 mm
4.1 kg
/II
2
) : 2.5 m/s or less
h
2
ENG901-1