Electrolux IK2355BR Benutzerinformation Seite 62

62 www.electrolux.com
Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera-
ture.
Water flows inside the re-
frigerator.
Water flows on the floor.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The FastFreeze is switch-
ed on.
The water drainage plug
is not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error
has occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Solution
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze ".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" .
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.