Troubleshooting - Zanussi ZFU27400WA Benutzerinformation

To remove the frost, follow the instructions be-
low:
• switch off the appliance and pull out the plug
from the wall socket
• remove any stored food, wrap it in several lay-
ers of newspaper and put it in a cool place
• remove the freezer drawers
• put insulating material around the drawers,
e.g. blankets or newspapers.
Defrosting can be accelerated by placing bowls
with hot water (not boiling) inside the freezer.
• Leave the door open and insert the plastic
scraper in the appropriate seating at the bot-
tom centre, placing a basin underneath to
collect the defrost water
• carefully scrape off the ice when it starts to
thaw (use a wood or a plastic scraper)
• when all the ice has melted, dry the interior
thoroughly and keep the scraper for future
use.
• switch on the appliance and replace the fro-
zen foodstuff.

Troubleshooting

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Problem
The appliance does not op-
erate. The Pilot light does
not flash.
The Pilot light flashes.
The Alarm light flashes.
The compressor operates
continually.
20
All manuals and user guides at all-guides.com
Activate the Fast Freeze function for some
hours so that it can reach the sufficient storing
temperature as soon as possible.
could damage it. Do not use a mechanical
device or any artificial means to speed up the
thawing process other than those
recommended by the manufacturer. A
temperature rise of the frozen food packs,
during defrosting, may shorten their safe
storage life.
Only a qualified electrician or competent person
must do the troubleshooting that is not in this
manual.
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The appliance is not working prop-
erly.
The temperature in the freezer is too
high.
The temperature is not set correctly.
The door is not closed correctly.
Caution! Never use sharp metal tools to
scrape off frost from the evaporator as you
Solution
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Contact a qualified electrician.
Refer to "Excessive Temperature
Alarm"
Set a higher temperature.
Refer to "Closing the door".
www.zanussi.com