Focal FPX series Gebrauchsanleitung Seite 7

FPX PREMIUM AMPLIFIER
U s e r m a n u a l
7
3.3.2 – Locate the negative (-) power cable. This cable should be as short as possible and ideally should not
exceed 1 meter in length, in order to ensure an optimal connection between the amplifier and the vehicle
chassis. The cable and its gauge must be in accordance with the table in 3.1. Locate an appropriate ground
(earth) point, then sand it to remove all traces of paint or other finish, thus optimising the quality of the
connection. Drill through the sheet metal you have previously sanded, making a hole to match the bolt you
have chosen, ensuring you are well clear of all cable routes, reservoirs or tanks or other sensitive vehicle
parts. Solder and insulate (using heat shrink sleeving) the earth cable to the FPX amplifier earth connector
supplied (Fig. 2).
fig. 2
3.4 - Connecting input connectors to your FPX amplifier
You may now begin the input/output cable connection phase.
Connect the RCA connectors (Fig. 3), paying attention to polarity and distribution. Connect the other end
to the amplifier's INPUTS connection panel.
fig. 3