Werbung
Verfügbare Sprachen
Verfügbare Sprachen
FPX PREMIUM AMPLIFIER
U s e r m a n u a l
10
3.6 – Power supply wiring
WARNING
The cable connecting the positive (+) battery terminal to the "+BATT" terminal on the amplifier must ALWAYS
have a fuse suitable for the power of your amplifier, positioned 40 cm or closer to your vehicle battery.
Fuse holder connections must be sealed.
Disassemble the fuse holder, taking care to remove the fuse. Secure the base of the fuse holder.
Cut a length of power cable between 10 and 40 cm (max.). Strip 1 cm and tin. Screw the cable into the ter-
minal on the battery side of the fuse holder. Crimp the power cable into an appropriate connector and screw
this to a source of battery power.
Strip 1 cm at the end of the remaining length of cable and tin. Screw the cable into the other terminal of the
fuse holder.
fig.7
Solder and insulate (using heat shrink sleeving) the positive (+) power cable to the FPX amplifier connector
supplied (Fig. 7).
3.7 – Start-up and checking
The connection phase is now complete. It now remains to check the power supply is good and the correct
operation of the system (head unit/amplifier/speakers). Set the source gain to minimum. Set the gain on
your amplifier at 1/3 of its total travel. Power up all the components. Once all components are switched on,
test at low volume.
4 - Control panel and connections
FPX 4.800
fig.8
Werbung
