INNOCIGS EVIC BASIC SET Bedienungsanleitung Seite 56

INNOCIGS EVIC BASIC SET – OPERATING & CHANGING THE MODES
2. Installing new atomizer coils
If an atomizer coil is replaced with one which has a greater resistance than the previous one, it is import-
ant to reset the "Base Resistance" of the atomizer. This is the resistance of the coil at room temperature.
Initiate a reset by pressing the fire button of the eVic Basic while the clearomizer is not attached. After
connecting the clearomizer with new head and the eVic Basic, "New Coil Right, Same Coil Left" will appear
on the display. Confirm that a new coil has been installed by pressing the "up" button.
If you see this message in other instances - especially when you reinstall the same coil which is still warm
from recent use - press the down button, so that the „base resistance" is not reset.
Always remember to adjust the operating mode of the coil used to ensure proper temperature control.
54