Operating & Changing The Modes - INNOCIGS EVIC BASIC SET Bedienungsanleitung

INNOCIGS EVIC BASIC SET – OPERATING & CHANGING THE MODES
Changing between the VT-Ni, VT-Ti, VT-SS316, VW, Bypass, TCR (M1, M2, M3) modes
Press the fire button three times in quick succession to enter the menu. The display will indicate you are in the settings menu
by flashing. Press the "up" button to toggle between TEMP (VT), TCR, POWER (VW) and BYPASS modes. Press the fire button
or wait until the display flashes ten times to confirm the current settings and exit the menu.
1. To select the TEMP or TCR mode, press the "down" button while the display is flashing to enter the submenus VT,
PWR, COIL and AMP. Press the "up" button to navigate between modes TEMP Ni, TEMP Ti, TEMP SS316 and TCR
M1, M2 and M3. Press the fire button to confirm your selection. If the AMP line flashes, press the "up" button to
switch between AMP, PUFF and TIME.
2. After selecting the POWER or BYPASS mode, press the "down" button while the display is flashing to enter the
submenus. To switch among AMP, PUFF and TIME use the "up" button, as soon as the AMP line is flashing.
48