Setting Screen Protection Time - Charging/Upgrading - Reset - INNOCIGS EVIC BASIC SET Bedienungsanleitung

INNOCIGS EVIC BASIC SET – USING THE DEVICES
Set the Screen Protection Time
While the device is switched on, press the fire button at the same time as the "up" button to
access the LED settings. Press the "up" button again to enter the screen protection settings.
Now use the "down" button to change the time interval after which the screen display shuts
off. Confirm your selection by pressing the fire button.
Charging and updgrading the eVic Basic
The micro USB port is located below the OLED screen of your eVic Basic. Connect the micro USB
charging cable for charging or to upgrade to the device. You can recharge the eVic Basic with the
USB cable connected to the USB port of a computer or with a suitable USB wall adapter. Whether
the battery is fully charged or is still in the charging process, you will see the charging status on
the battery icon on the display. When it is fully charged, the display will go out.
Reset
Should the device get stuck while upgrading, just press the "up" botton and then insert a needle into the restart
hole to initiate a restart.
41