Installation On A Trussing System; Attachment - EuroLite SB-4 Bedienungsanleitung

The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
A skilled person has to approve the flying construction before every use. This approval includes appearance
and load tests when moved in accordance with the BGV-A2 for electrical devices.
Procedure:
The installation should be attached outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material. If you lack these qualifications, do not attempt the installation yourself, but instead use a
professional structural rigger. Improper installation can result in bodily injury and.or damage to property.
The installation has to be attached out of the reach of people.

Installation on a trussing system

Caution: Trussing installations may cause severe injuries when crashing down! If you have doubts
concerning the safety of a possible installation, do NOT install the trussing!
Before rigging make sure that the installation area can hold a minimum point load of 10 times the
installation's weight.
For suspending on crossbeams, split boxes must always use a minimum of two hooks.
Attach the upper fixation of a C-hook to the crossbeam and tighten the fixation screw. Attach the Alubar to
the lower fixation of a C-hook and tighten the fixation screw.
Secure the suspended part with a safety-rope that can hold at least 12 times the weight of the installation.
You must only use safety-ropes with quick link with screw cap. Pull the safety-rope through the safety rope
hole and over the trussing system or a safe fixation spot. Insert the end in the quick link and tighten the
safety screw.
The trussing system must always be earthed!

Attachment

Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
15/20 00026991.DOC, Version 2.0