Operating Determinations - EuroLite SB-4 Bedienungsanleitung

DANGER TO LIFE!
The electric connection must only be carried out by a qualified electrician!
This device falls under protection-class I. Wrong voltages or power outlets can lead to the destruction of the
device and to mortal electrical shock.
Never let the power-cord come into contact with other cables! Handle the power-cord and all connections
with the mains with particular caution! Never touch them with wet hands, as this could lead to mortal
electrical shock.
Never modify, bend, strain mechanically, put pressure on, pull or heat up the power cord. Never operate next
to sources of heat or cold. Disregard can lead to power cord damages, fire or mortal electrical shock.
The cable insert or the female part in the device must never be strained. There must always be sufficient
cable to the device. Otherwise, the cable may be damaged which may lead to mortal damage.
Make sure that the power-cord is never crimped or damaged by sharp edges. Check the device and the
power-cord from time to time.
If extension cords are used, make sure that the core diameter is sufficient for the required power
consumption of the device. All warnings concerning the power cords are also valid for possible extension
cords.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power-cord, if applicable, by the plug. Never pull out the plug by tugging the power-cord. Otherwise, the
cable or plug can be damaged leading to mortal electrical shock. If the power plug or the power switch is not
accessible, the device must be disconnected via the mains.
If the power plug, if applicable, or the device is dusty, the device must be taken out of operation,
disconnected and then be cleaned with a dry cloth. Dust can reduce the insulation which may lead to mortal
electrical shock. More severe dirt in and at the device should only be removed by a specialist.
There must never enter any liquid into power outlets, extension cords or any holes in the housing of the
device. If you suppose that also a minimal amount of liquid may have entered the device, it must immediately
be disconnected. This is also valid, if the device was exposed to high humidity. Also if the device is still
running, the device must be checked by a specialist if the liquid has reduced any insulation. Reduced
insulation can cause mortal electrical shock.
There must never be any objects entering into the device. This is especially valid for metal parts. If any metal
parts like staples or coarse metal chips enter into the device, the device must be taken out of operation and
disconnected immediately. Malfunction or short-circuits caused by metal parts may cause mortal injuries.
The total weight of the installation (=total weight of all individual parts) must never exceed the maximum load
of the installation area.
If the power distributor will be installed on a trussing system or be suspended, it must always be secured with
an appropriate safety-rope!
Keep away children and amateurs!
Never leave this device running unattended.

OPERATING DETERMINATIONS

This device is a power distribution for supplying current to other devices.
This product is only allowed to be operated with an alternating voltage of 230-400 V, 50 Hz and was
designed for indoor use only.
12/20 00026991.DOC, Version 2.0