hanseatic WQP12-7635 Gebrauchsanleitung Seite 60

Page EN-26 Setup or under-worktop installation and connection
4. Press the P button (12) repeatedly until
the LED to the right of the
symbol lights up.
5. Start the programme with the button
(13).
The programme will begin after a few sec-
onds.
6. Ensure that no water comes out and no
unusual sounds are emitted.
7. When the programme is finished, an
acoustic signal will sound.
Switch the dishwasher off using the but-
ton (1).
8. Slightly open the door to allow the moist
air to escape more effectively.
9. Close the valve.
If no water has escaped and no unusual nois-
es have been heard, the dishwasher is ready
for operation and you can now load it with
dishes.
programme