hanseatic WQP12-7635 Gebrauchsanleitung Seite 43

Trip hazard!
An open dishwasher door can quickly
become a trip hazard.
Close the door after every use.
■
Only leave the door slightly open to
■
cool down.
Risk of damage!
Improper handling of the appliance
may result in damage.
Never leave the appliance unsuper-
■
vised for an extended period when
the tap is on.
During storms or when going on hol-
■
iday, always withdraw the mains plug
from the socket and close the water
tap.
If there is a risk of frost, loosen the in-
■
let hose and allow the water to run
off.
Only use regenerating salt which is
■
suitable for dishwashers.
Only add dishwasher salt immediate-
■
ly before the next main dishwashing
cycle, as dishwasher salt which has
overfl owed can damage the seals and
fi lters of the appliance.
Immediately remove any spilt dish-
■
washer salt with a damp towel, as
otherwise the stainless steel surfaces
may be affected.
Ensure that the dishwasher detergent
■
and rinse aid are suitable for the ap-
pliance.
Wipe away rinse aid which has over-
■
fl owed immediately as otherwise it
can lead to excessive foaming which
can compromise the results delivered
by the dishwasher.
Do not overload the appliance.
■
Safety
Position the upper dish rack at the
■
highest setting if very tall dishes are
in the lower dish rack, as otherwise the
upper spraying arm will be blocked.
The seals of the door are sensitive to oil
and grease.
Do not apply grease to the door seals.
■
The door seals can be damaged by un-
suitable cleaning agents.
Do not use harsh, aggressive, sol-
■
vent-based or abrasive cleaners.
The appliance is designed for a water
pressure of 0.4-10 bar (0.04-1.00 MPa,
2
40-100 N/cm ).
If the water pressure is higher than
■
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
Ensure that the inlet hose is not
■
kinked and is carefully connected.
Do not cut through the inlet hose.
■
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist.
Do not use old or previously installed
■
inlet or outlet hoses.
The outlet hose must have a mini-
■
mum diameter of 40 mm so that the
water can be pumped away unhin-
dered.
Do not attach the outlet hose your-
■
self, have it installed by a special-
ist plumber. Have the outlet hose
checked regularly for damage or
kinks.
Page EN-9