Troubleshooting - AEG 86585IH Benutzerhandbuch

46 www.aeg.com

10. TROUBLESHOOTING

10.1 Troubleshooting
Problem
The tumble
dryer does
not operate.
Unsatisfac-
tory drying
results.
The door
does not
close.
Err (Error)
on the dis-
play.
No drum
light
1)
Possible cause
The tumble dryer is not con-
nected to mains supply.
The loading door is opened.
The Auto/Off button was not
pushed.
The Start/Pause button was not
pushed.
The appliance is in the standby
mode.
Incorrect programme selection.
The filter is clogged.
The Dry Plus function was in
minimum mode.
The heat exchanger filters are
clogged.
Too high volume of the load.
The airflow grill is clogged.
Dirt on the inner surface of the
drum.
Too high water hardness.
The filter not locked in the po-
sition.
The laundry is locked between
the door and the seal.
You try to change the pro-
gramme or the function after
the start of the cycle.
The function you try to activate
is not applicable with the selec-
ted programme.
Defective drum light.
Remedy
Connect in at mains socket.
Check fuse in fuse box (domes-
tic installation).
Close the loading door.
Push the Auto/Off button.
Push the Start/Pause button.
Push the Auto/Off button.
Do the selection of the applica-
2)
ble programme.
3)
Clean the filter.
Change the Dry Plus function
to the moderate or maximum
mode.
Clean the heat exchanger fil-
3)
ters.
Obey the maximum load vol-
ume.
Clean the airflow grill in the
bottom of the appliance.
Clean the inner surface of the
drum.
Set applicable water hard-
4)
ness .
Put the filter in the correct posi-
tion.
Put the load correctly in the
drum.
Turn the tumble dryer off and
on. Make the new selection.
Turn the tumble dryer off and
on. Make the new selection.
Contact the service centre to
replace the drum light.