Maintenance - Kress KUB50.2 Originalbetriebsanleitung

For tools with a deep hole for screwdriver bits
When using this type of screwdriver bits,
A=17mm
follow the installation steps shown in Fig.
B=14mm
B.
When using this type of screwdriver bits,
A=12mm follow the installation steps shown in
B=9mm Fig. C. Note: Screwdriver bit element is
required.
EN
12
To remove bits:
When removing the screwdriver bit, pull the socket in
the direction of the arrow shown in Fig. B/C and pull the
screwdriver bit out.
2. SWITCH LOCK
A completely new electromagnetic directional technique
is used for the switch lock, which is more reliable than
the mechanical directional structure; the power supply of
machine will be completely cut off when the shift lever is
in the middle position, and the machine will not start when
forcibly pressing the button;
This function is helpful to prevent the machine from
accidental startup when it is not in use.
3. REVERSIBLE
For drilling and screw driving use forward rotation marked "
marked "
A
screws or release a jammed drill bit.
Warning: Never change the direction of rotation when
the chuck is rotating, wait until it has stopped!
4. LED LIGHT (6)
To turn on the light simply press the On/Off Switch (5). When
you release the On/Off Switch, the light will be off.
B
LED lighting increases visibility-great for dark or enclosed
area.It will flash when power gets low.
5. ELECTRONIC SPEED CONTROL KNOB (8)
The speed can not be adjusted during the running of
machine if the electronic speed control knob is locked.

MAINTENANCE

Your power tool requires no additional lubrication
or maintenance.
There are no user serviceable parts in your power tool. Never
use water or chemical cleaners to clean your power tool.
Wipe clean with a dry cloth. Always store your power tool
" (lever is moved to the left). Only use reverse rotation
" (lever is moved to the right) to remove