Kress KUB50.2 Originalbetriebsanleitung Seite 10

Impact rate
Max torque
Chuck capability
Machine Weight
NOISE INFORMATION
A weighted sound pressure
A weighted sound power
EN
K &K
10
pA wA
Wear ear protection.
WEAR EAR PROTECTION
Vibration total values (triax vector sum) determined ac-
cording to EN 62841:
The declared vibration total value and the declared noise
emission value have been measured in accordance with a
standard test method and may be used for comparing one
0-1600/0-3500/0-
4000bpm
140N.m
6.35mm
0.88kg
L = 85.1 dB(A)
pA
L = 96.1 dB(A)
wA
5 dB(A)
Vibration emission value
a =8.135 m/s²
h
Uncertainty K = 1.5 m/s²
tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a preliminary
assessment of exposure.
WARNING:The vibration and noise emissions during
actual use of the power tool can differ from the
declared value depending on the ways in which the tool
is used especially what kind of workpiece is processed
dependant on the following examples and other variations on
how the tool is used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it
is sharp and in good condition.
The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design and
these instructions.
This tool may cause hand-arm vibration syndrome if
its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use should
also take account of all parts of the operating cycle such
as the times when the tool is switched off and when it
is running idle but not actually doing the job. This may
significantly reduce the exposure level over the total
working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and
keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration