Troubleshooting; Maintenance; Environmental Protection - Kress KUB60 Handbuch

Removing the Bits
Forward / Reverse / Lock
WARNING: Never change
the direction of rotation when
the chuck is rotating, wait until it is
stopped!
OPERATION
Operating the On/Off Switch
Warning: Do not operate
for long periods at low
speed because excess heat will
be produced internally.
Variable 3-Speed
Press the red button to select
preferred rotation speed, levels 1
to 3, with 3 being the fastest. The
operating speed will be illuminated.
LED Light Indicator
Before operation, the light will be
activated when the On/Off switch
is slightly depressed, and will
automatically turn off 10 seconds after
the On/Off switch is released.
The tool and battery are equipped
with a protection system. The Light
will quickly flash (approximately once
a second, and stop flashing when
10
you release the trigger), the system
will automatically cut off power to the
EN
tool to extend battery life. The tool will
automatically stop during operation
if the tool and/or battery are placed
under one of the following conditions:
• Overloaded: The tool is operated
in a manner that causes it to draw
an abnormally high current. In this
situation, release the Trigger Switch
on the tool and stop the application
that caused the tool to become
overloaded. Then pull the Trigger
Switch again to restart.
• Overheated: Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In
this situation, let the Tool and Battery
cool before pulling the Trigger Switch
again.
• Low battery voltage: The
remaining Battery capacity is too low
and the tool will not operate. In this
situation, remove and recharge the
Battery.
Warning: To turn on the light,
press the On/Off switch and
make sure the Forward/Reverse
Rotation Control is on right/left
position.
TROUBLE SHOOTING
See Fig. C2
1. I CAN NOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger only in one
See Fig. D1,
direction. Turn the battery around until it can be inserted
D2, D3
into the slot.
2. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having not
used a battery pack for a prolonged time will reduce the
battery pack working time. This can be corrected after
several charge and discharge operations by charging &
working with your drill. Heavy working conditions such
See Fig. E
as large screws into hard wood will use up the battery
pack energy faster than lighter working conditions. Do
not re-charge your battery pack below 0
40 C as this will affect performance.
o

MAINTENANCE

Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
See Fig. E
of tool and battery is 0℃-45℃.
The recommended ambient temperature range for the
charging system during charging is 0℃-40℃.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
C and above
o