Kress KUB50.2 Originalbetriebsanleitung Seite 11

and noise accessories.
Plan your work schedule to spread any high vibration tool
use across a number of days.
ACCESSORIES
2.0Ah lithium battery pack(KPB1202)
Charger (KCH1202)
Driver bits
Driver bit element
50mm screwdriver bit (PH2)
We recommend that you purchase your accessories from the
same store that sold you the tool. Choose the type according
to the work you intend to undertake. Refer to the accessory
packaging for further details. Store personnel can assist you
and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book
carefully.
Intended use:
This tool is intended for the fastening and loosening of bolts,
nuts and various threaded fasteners. This tool is not intended
for use as a drill.
BEFORE PUTTING INTO OPERATION
A) BATTERY CHARGING
The battery charger supplied is matched to the Li-ion battery
installed in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off by
means of a protective circuit: The chuck no longer rotates.
KUB50.2
In a warm environment or after heavy use, the battery pack
may become too hot to permit charging. Allow time for the
2
battery to cool down before recharging.
When the battery is charged for the first time and after
1
prolonged storage, the battery will only accept approximately
60% charge. However, after several charge and discharge
1
cycles the battery will accept a 100% charge.
1
B)TO REMOVE OR INSTALL BATTERY PACK (SEE A)
Depress the battery pack release button to release and slide
1
the Battery Pack (4) out from your tool. After recharge, slide
it back into your tool. A simple push and slight pressure will
be sufficient.
OPERATION
1.HOW TO INSTALL AND REMOVE A SCREWDRIVER
BIT AND SOCKET
TO INSTALL BITS:
A). When installing the screwdriver bit, pull the socket in the
direction of the arrow and insert the screwdriver bit all the
way to the bottom of the socket. Then, release the socket to
lock the screwdriver bit. (See Fig. B)
B). When installing the screwdriver bit, pull the socket in the
direction of the arrow and insert the screwdriver bit element
and the screwdriver bit all the way to the bottom of the socket.
Then, release the socket to lock the screwdriver bit.(See Fig. C)
Note: Use only the screwdriver bits with the
illustrated inserts
EN
11