tau LUXE-M Bedienungs- Und Wartungsanleitung Seite 22

6.7 Spring fitting
6.8 Bar balancing
Continue with the electrical connections to the control panel (see the chapter on electrical connections).
Note: check the spring works correctly.
IMPORTANT! For a correct operation of the barrier, when the boom is in vertical position the spring must not
be completely unloaded.
Now proceed with the assembly of the spring, hooking it
to the screw with eyelet and to the hole on the metal sheet
at the base of the cabinet, then carry out a first preload by
hand-turning the central body of the tie rod and the eyelet.
Continue with bar balancing.
Before balancing the bar, check with the table in paragraph
"3. Optional accessories "the congruence between the cho-
sen spring, the accessories to be applied and distance are
adequate. Correct balancing is essential for the barrier to
work properly.
This operation must be carried out only when the bar has
been installed permanently with all its accessories.
operate the manual release (see the "Manual release" chapter)
keeping at a safe distance. The rod must move by itself to 45°,
otherwise load/unload the spring (if the rod tends to rise abo-
ve 45° the spring must be unloaded by turning the central body
clockwise; on the contrary, if it doesn't reach 45°, the spring must
be loaded by turning the central body counterclockwise). Lower
the rod and release it, check that it has reached 45°.
If a load is needed that is greater/lower than that per-
mitted when balancing, move the eyelet into the hole
on the right or left to increase/decrease the load capa-
city.
22