Manual Release - tau LUXE-M Bedienungs- Und Wartungsanleitung

After releasing the automation (see the "Manual release" chapter), proceed as follows:
1_ Remove the connecting rod by taking away the fixing screws and lower the rocker arm until it stops. Crank the handle as
shown in the picture, rotate the lever 180° to the previous position and tighten it to the opposite side of the rocker arm.
2_ Once the opening direction has been modified, invert the motor connections (see K206MA instructions). If the barrier must
be modified from LH to RH, the operations are the same.
Step 1
3_ Adjustment procedure
1. Adjust the opening and closing limit switches (1)
2. Fix the screws (2) and (3) on the crank close to the joint maintaining the minimum angle indicated in the figure in the two
positions in closing (2) and opening (3)
3. If you are unable to respect the minimum angle indicated, vary the length of the connecting rod by screwing or un-
screwing the two joints.
BARRIERA CHIUSA BARRIERE FERMEE
CLOSE BARRIER
BARRERA CERRADA
GESCHLOSSENE SCHRANKE BARREIRA FECHADA

6.5 Manual release

Step 2
1
1
2
Step 3 Step 4
3
WARNING! Releasing and any other manual
operation must be carried out only with the
bar fitted. It is absolutely forbidden to ope-
rate the barrier without the bar fitted.
1_ Introduce the supplied release key;
2_ turn the key through approx. 330° in a clockwise
direction (if it is a bit tight at the beginning, apply
more force, there is no danger of causing damage).
Turn the key as far as it will go before manually
operating the bar.
When released, the bar must automatically go to
the balance position (ca. 45).
WARNING! Releasing can be potentially
dangerous for the user when for any reason
whatsoever (bar badly fitted during instal-
lation, bar broken due to an accident, etc.)
the springs do not guarantee balancing any
longer!
They can cause the bar coupling and/or the
bar itself to rotate suddenly.
20
Step 5
BARRIERA APERTA BARRIERE OUVERTE
OPEN BARRIER BARRERA ABIERTA
OFFENE SCHRANKE BARREIRA ABERTA